1957-62 Borg Warner 4-Speed Linkage Installation

The 4-Speed transmission gearshift linkage utilizes three shift rods and levers. A simple gauge block will aid in making the proper adjustments. The adjustments can be made without the gauge block by having an assistant hold the manual shift lever in the neutral positions.

  1. Remove transmission gearshift lever seal from the floor pan.
  2. Place transmission in neutral and install gauge block in position as shown in illustration.
  3. Remove the cotter pin, anti-rattle washer and clevis pin at each shift lever.
  4. On each shift rod, adjust the threaded clevis to permit free entry on the clevis pin into the hole in the transmission shift lever.
  5. Reconnect the clevises to the shift levers.

Remove the gauge block and check the shifts. If any roughness still exists, one of the clevises may require adjustment of approximately one-half turn. Determine the rod and clevis requiring adjustment by sighting along the slot where the gauge block was used in step 2.

Purchase 269K 1957-62 Borg Warner 4-Speed Linkage Kit by clicking here.

1956-62 Windshield Wiper Transmission Installation

Note the wiper transmission in Figure 1. Two people will be required for the first step and for the final step. One person should stand outside the car to push down on the left windshield wiper transmission drive shaft, which separates the upper and lower clutches.

From under the dash, pull on the cables; this permits the clutches to rotate, extending the length of both cables. Once the cables are fully extended, have the second person release the transmission shaft. The clutches will lock back together and the cables will be held in their extended positions. Repeat this procedure with the right transmission.

Now that both transmission assemblies have their cables extended and in the locked position, you’re ready to connect the cables to the wiper drum assembly. Refer to Figure 2 and hook the cable ends on the drum as indicated.

Once the cables are attached to the drum, have the other person press down on the left wiper transmission shaft again. The clutches will be released, and snap back to spring load the cables. Now repeat on the right transmission, check the cables on the drum one last time.

Note that the upper cable is 24” long and the lower cable is 24 5/8” long, both dimensions include the ends.

Purchase 10-Wiper Trans 1958-62 Windshield Wiper Transmission Reconditioning Service by clicking here.

New Summer Hours Begin April 10!

With the weather finally turning a little warmer, more and more of us are starting to work on our cars again. With this in mind, Paragon will now be open again on Saturday’s! Our full business hour schedule is below for your convenience.

Phone Order/Showroom Hours : Monday – Friday: 8am – 6:30pm EST, Saturday: 10am – 2pm EST (Starting April 10)

For 24/7 online ordering, our website is always available at www.paragoncorvette.com. If you have any questions or concerns, leave us a comment or drop us an email and we’ll get back with you ASAP!

Introducing Paragon’s New Customer Garage

Getting the parts you need for your Corvette the first time, just got easier with Paragon’s New Customer Garage!

This new feature on our website allows you to create a profile of your Corvette(s) specs including, interior, exterior and convertible top colors, engine block, horsepower, heads, carburetor/fuel injection, distributor, alternator/generator and regular production options (RPO’s), which are attached to every order you make on our website. This allows us to ensure that you get the correct parts for your particular car when you order from our website. You can even opt into our public photo gallery and show your ride off , and check out photos of your fellow enthusiasts cars in the gallery.
Creating a profile is simple just click here or follow the link below to add your car to the Customer Garage!