How to Install 1963 – 1982 Corvette Control Arm Pivot Shafts

Watch one of our technician’s walk you through step-by-step, installing the pivot shafts in your 1963 – 1982 Corvette control arms. Don’t have the tools, or not feel comfortable doing this at home? Call us at 1-800-882-4688 and we can set up having it done for you!

1967 Seat Track Roller Installation

Remove the seat track from seat frame. Position the track so that you are looking at the bottom (View A). Slide inner track toward the front, so that you can access the dimple on the outer case. Remove the dimple that is located just inside of the hole by striking with a blunt punch and […]

1964-67 Parking Brake Pawl & Spring Installation

While the spring and pawls can be replaced on the car, it is much easier to remove the handle assembly from the car first. Remove the stop pin by lining up the stop pin with the access hole and using a flat punch to drive the pin out from the bottom access hole. Do not […]

1962-64 Powerglide Shifter Linkage Installation

Set control rod bell crank (A) in Park position. Set control shaft lever (B) in Park position. With both the bell crank and lever held in Park position, assemble control rod (C) to lever (B), then adjust clevis on rod (C) for easy entry into lever (A). **Please note that parts numbered in the schematic […]

1957-62 Muncie 4-Speed Linkage Installation

The 4-Speed transmission gearshift linkage utilizes three shift rods and levers. A simple gauge block will aid in making the proper adjustments. The adjustments can be made without the gauge block by having an assistant hold the manual shift lever in the neutral positions. Remove transmission gearshift lever seal from the floor pan. Place transmission […]