Wednesday, October 20th, 2010 10:31 am GMT -5 
jlangley Watch one of our technician’s walk you through step-by-step, installing the pivot shafts in your 1963 – 1982 Corvette control arms. Don’t have the tools, or not feel comfortable doing this at home? Call us at 1-800-882-4688 and we can set up having it done for you!
Thursday, March 25th, 2010 03:49 pm GMT -5 jkincer Wind retractor clockwise 7-8 full turns. While winding, be careful to hold retractor firmly in hand. Turn belt over with opposite hand. Push belt under tabs. Position retractor in the middle of the outboard webbing. (Figures 1 & 2) Position retractor squarely with belt and crimp tabs securely against belt webbing. (Figure 3) Check for [...]
Posted in C-2 Corvette Parts, Tech-Tips 
Tags: 1965, 1966, C-2 (1963-67), corvette parts, Corvette Restoration, installation, seat belt 
3 Comments » Thursday, March 25th, 2010 11:34 am GMT -5 jkincer **Detailed Bushing Installation** Distributor Rebuild Guide Remove distributor assembly from engine and place lower part of housing in vise, clamping securely. Remove cap and rotor from cam assembly. Lift off springs and weights from cam. With a drift punch drive out lower distributor gear split pin. Next, remove lower gear and shim. Remove the brass [...]
Posted in C-2 Corvette Parts, C-3 Corvette Parts, Tech-Tips Tags: 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, C-1 (1953-62), C-2 (1963-67), C-3 (1968-82), corvette parts, Corvette Restoration, distributor, installation No Comments » Wednesday, March 24th, 2010 02:26 pm GMT -5 jkincer Remove the seat track from seat frame. Position the track so that you are looking at the bottom (View A). Slide inner track toward the front, so that you can access the dimple on the outer case. Remove the dimple that is located just inside of the hole by striking with a blunt punch and [...]
Posted in C-2 Corvette Parts, Tech-Tips Tags: 1967, C-2 (1963-67), corvette parts, Corvette Restoration, installation, seat track 1 Comment » Wednesday, March 24th, 2010 01:50 pm GMT -5 jkincer While the spring and pawls can be replaced on the car, it is much easier to remove the handle assembly from the car first. Remove the stop pin by lining up the stop pin with the access hole and using a flat punch to drive the pin out from the bottom access hole. Do not [...]
Posted in C-2 Corvette Parts, Tech-Tips Tags: 1964, 1965, 1966, 1967, C-2 (1963-67), corvette parts, Corvette Restoration, installation, parking brake 1 Comment »
