1965-66 Seatbelt Retractor Installation

  1. Wind retractor clockwise 7-8 full turns. While winding, be careful to hold retractor firmly in hand.
  2. Turn belt over with opposite hand. Push belt under tabs. Position retractor in the middle of the outboard webbing. (Figures 1 & 2)
  3. Position retractor squarely with belt and crimp tabs securely against belt webbing. (Figure 3)
  4. Check for proper operation of retractor and make and adjustment required.

Installation Notes:

  • If it is necessary to rewind retractor, do not exceed 9 full turns.
  • Caution, do not install retractor to the buckle half of the belt.

Use of belt:

  • Seatbelt must be fully extended when in use. Pull belt so it is fully unwound from retractor, then connect belt and make adjustment at the buckle for proper fit.
Purchase parts online at Paragon
Comments
3 Responses to “1965-66 Seatbelt Retractor Installation”
  1. jkincer says:

    We now have new 1964-E66 seat in stock and ready to ship! These aren’t generic service replacement belts, our belts should make judges happy and keep your Corvette looking original.

    Part number 14589K Seat belt assembly kit, includes L.H. & R.H belt. Please note that these belts do not include the buckle disk decal (part number 234K) or the sewn on labels. These parts must be purchased separately. See part number 10-Seat Belt Service for installation of these parts. The list price $305.00.

Trackbacks
Check out what others are saying...
  1. […] Paragon Corvette Reproductions | Official Blog – 1965-66 Seatbelt Retractor Installation « Cor… […]

  2. […] Paragon Corvette Reproductions | Official Blog – 1965-66 Seatbelt Retractor Installation « Cor… […]